Technology
13 min read

iPhone Face ID Not Working? 8 Fixes to Restore Unlock

Person holding an iPhone showing the lock screen with face recognition prompt

Face ID that fails to recognize your face, asks for your passcode repeatedly, or shows the "Face ID is Not Available" error makes unlocking your iPhone slow and frustrating. When iphone face id not working becomes an issue, the cause is usually something you can fix yourself. Face ID uses a TrueDepth camera system built into the notch or Dynamic Island at the top of the screen to project and read over 30,000 invisible infrared dots on your face. Anything that blocks those dots, changes your facial appearance significantly, or interferes with the infrared sensors will cause Face ID to fail. Most Face ID problems are caused by something covering the sensors or by conditions that have changed since you enrolled your face, and these can be fixed in minutes.

Person looking at a smartphone screen while holding the phone in front of their face

Photo by George Becker on Pexels

Why Face ID Stops Working — Iphone Face Id Not Working

The TrueDepth camera sensors are blocked or dirty. Face ID relies on multiple sensors packed into a small area at the top of the iPhone: an infrared camera, a flood illuminator, and a dot projector. Any obstruction over these sensors prevents Face ID from scanning your face. Screen protectors that extend over the notch or Dynamic Island are the most common culprit. Even a thin film of oil, sunscreen, or makeup residue on the sensor area can interfere with the infrared light used to map your face. Cases with raised edges that partially cover the sensor area cause the same problem.

Your facial appearance has changed significantly. Face ID adapts gradually to changes in your appearance, such as growing or trimming a beard, getting a new haircut, or aging. However, sudden large changes can prevent recognition. Wearing sunglasses that block infrared light (polarized lenses are especially problematic), wearing a face mask that covers your nose and mouth, heavy makeup that alters the shape of your face, or facial bandages after a medical procedure all change your facial geometry enough to fail the Face ID scan.

You are holding the phone at the wrong distance or angle. Face ID works when the iPhone is held at arm's length to about 10 inches from your face, roughly 10 to 20 inches away. Holding the phone too close (like when reading in bed with the phone inches from your face) or too far away prevents the dot projector from mapping your features properly. The angle matters too. Face ID expects you to look roughly straight at the screen. Holding the phone flat on a table and glancing at it from a steep angle reduces recognition reliability.

Face ID is not set up for the feature you are trying to use. iOS lets you control which features use Face ID individually. You may have Face ID enabled for unlocking the phone but disabled for App Store purchases, password autofill, or specific third-party apps. Each of these has a separate toggle, and disabling one does not affect the others. If Face ID works for unlocking but not for confirming an App Store download, the issue is a settings toggle, not a hardware or recognition problem.

A software glitch has disabled the Face ID subsystem. After certain iOS updates, after a hard crash, or when the phone runs out of battery and shuts down unexpectedly, the Face ID system can enter an error state. The phone displays "Face ID is Not Available, try setting up Face ID later" and refuses to scan regardless of conditions. A restart usually clears this state. If it does not, a Face ID re-enrollment is needed.

The TrueDepth camera hardware is damaged. The TrueDepth camera system is located behind the front glass of the iPhone. A cracked screen that runs through the notch or Dynamic Island area, a drop that displaced the sensor module internally, or liquid damage to the sensor electronics can permanently disable Face ID. Apple's Face ID hardware is paired to the device at the factory, and only Apple or Apple Authorized Service Providers can repair or replace it.

Clean the TrueDepth Camera Area

The TrueDepth sensors sit in the notch (iPhone X through iPhone 14) or the Dynamic Island (iPhone 14 Pro and later) at the top center of the screen. This area needs to be completely clear and clean for Face ID to work reliably.

  1. Remove any screen protector that covers the notch or Dynamic Island area. Even screen protectors marketed as "Face ID compatible" can develop bubbles, scratches, or a film of grime over the sensor area that degrades performance over time.
  2. Wipe the notch or Dynamic Island area with a clean, dry microfiber cloth. Pay attention to the small openings where the sensors sit. Oil from your fingers, sunscreen, makeup, and facial moisturizer all transfer to this area during normal use.
  3. Check your case. Some cases with raised bezels or built-in screen protectors extend over the sensor area. Remove the case entirely and test Face ID without it.
  4. Hold the phone under good lighting and look closely at the sensor area. If you see any residue, adhesive from a removed screen protector, or physical damage like a crack running through the notch, address it before continuing with other troubleshooting steps.

After cleaning, lock the phone, then wake it and try Face ID. If cleaning resolved the issue, consider switching to a screen protector that does not cover the sensor area, or clean the sensor area as part of your regular phone maintenance routine.

Close-up of a smartphone screen glowing softly in a dimly lit room

Photo by Lisa Fotios on Pexels

Check Face ID Settings

Go to Settings > Face ID & Passcode and enter your passcode. This screen shows every feature that uses Face ID and whether each is enabled.

  • iPhone Unlock: Must be on for Face ID to unlock the lock screen.
  • iTunes & App Store: Must be on to confirm app downloads and purchases with Face ID instead of a password.
  • Wallet & Apple Pay: Must be on for contactless payments with Face ID.
  • Password AutoFill: Must be on to use Face ID to fill saved passwords in Safari and apps.
  • Other Apps: Lists third-party apps that have requested Face ID access. Toggle each one individually.

If a specific feature does not respond to Face ID but others do, toggle the feature off, wait 5 seconds, and toggle it back on. This re-registers the Face ID trigger for that specific function.

Also check Require Attention for Face ID on this same screen. When enabled, Face ID requires you to look directly at the phone with your eyes open. If you wear sunglasses that block infrared light or have a condition that makes direct eye contact difficult, turning this option off allows Face ID to work without detecting eye direction. The trade-off is slightly reduced security, since the phone could be unlocked while you are asleep or looking away.

Set Up an Alternate Appearance

If Face ID fails because your appearance changes regularly (you wear glasses sometimes, alternate between clean-shaven and bearded, or wear head coverings), setting up an alternate appearance teaches Face ID a second version of your face.

Go to Settings > Face ID & Passcode and tap Set Up an Alternate Appearance. Follow the enrollment process while wearing the appearance that Face ID currently does not recognize. For example, if Face ID works without glasses but fails with glasses, enroll the alternate appearance while wearing your glasses.

Face ID supports only two enrolled appearances (the primary and one alternate). If you need recognition across more than two looks, choose the two most common ones. Face ID's adaptive learning will gradually improve recognition of variations between the two enrolled appearances over time as you use the phone.

Hold the Phone at the Correct Distance and Angle

Face ID works best when the iPhone is held at a natural viewing distance, roughly 10 to 20 inches from your face. Hold the phone in portrait orientation (vertical) and look directly at the screen. The phone does not need to be perfectly level, but extreme angles reduce reliability.

Common situations where distance and angle cause problems:

  • Lying in bed: Holding the phone too close to your face or at an awkward angle while lying on your side. Try holding the phone at arm's length directly above your face.
  • Phone on a desk: If the phone is flat on a desk and you glance down at it from a standing position, the angle is too steep. Pick the phone up or lean over to face it more directly.
  • Phone mounted in a car: A dashboard or windshield mount may position the phone at an angle where Face ID cannot see your full face. Adjust the mount angle to face you more directly.

Wide view of a smartphone on a table in a bright room with natural lighting

Photo by Min An on Pexels

Restart Your iPhone

A restart clears the Face ID subsystem state and resolves the "Face ID is Not Available" error that can appear after iOS updates, crashes, or unexpected shutdowns.

Press and hold the Side button and either Volume button simultaneously until the "slide to power off" slider appears. Slide to turn off. Wait 10 seconds, then press and hold the Side button until the Apple logo appears.

After the restart, you must unlock with your passcode once before Face ID reactivates. This is a security requirement. After that first passcode unlock, test Face ID by locking the phone and waking it. If the "Face ID is Not Available" error is gone and Face ID scans your face, the issue was a software glitch that the restart resolved.

Reset Face ID and Re-Enroll

If Face ID still fails after cleaning, adjusting settings, and restarting, reset the Face ID data and set it up from scratch. This clears the stored face map and starts fresh.

  1. Go to Settings > Face ID & Passcode and enter your passcode.
  2. Tap Reset Face ID. This immediately deletes the stored face data.
  3. Tap Set Up Face ID and follow the on-screen instructions. You will be asked to slowly rotate your head in a circle twice so the TrueDepth camera can capture your face from all angles.
  4. During enrollment, make sure you are in a well-lit area (not harsh backlighting), hold the phone at a natural distance, remove glasses and face coverings for the primary enrollment, and look directly at the screen.
  5. After primary enrollment completes, optionally set up an alternate appearance for your most common different look (with glasses, with a hat, or similar).

A fresh enrollment often resolves persistent Face ID failures because the original enrollment may have been done under poor lighting conditions, at an awkward angle, or with a facial appearance that you no longer maintain.

Update iOS

Apple regularly releases iOS updates that improve Face ID performance. Past updates have fixed issues with Face ID failing in low light, not recognizing users wearing masks (added in iOS 15.4), and the TrueDepth camera failing to initialize after certain operations.

Go to Settings > General > Software Update. Install any available update. After the update, test Face ID in several conditions: indoors, outdoors, in low light, and with your alternate appearance if you have one set up.

When Face ID Needs Hardware Repair

If Face ID does not work after cleaning, resetting, re-enrolling, and updating iOS, the TrueDepth camera hardware may be damaged. Signs of hardware failure include the "Face ID is Not Available" error persisting after every restart, Face ID not appearing in Settings at all, and the front-facing camera also not working (since it shares components with the TrueDepth system).

Contact Apple Support or visit an Apple Store for diagnosis. Face ID hardware repairs can only be done by Apple or Apple Authorized Service Providers because the TrueDepth camera module is paired to the iPhone at the factory. Third-party screen replacements that disturb the TrueDepth camera wiring can permanently disable Face ID.

Smartphone lying on a dark surface with ambient lighting reflecting on the screen

Photo by Tyler Lastovich on Pexels

Related articles you might find helpful:

Frequently Asked Questions About Face ID Problems

Does Face ID work with sunglasses?

Most sunglasses work with Face ID, but polarized lenses and certain tinted lenses block the infrared light that the TrueDepth camera uses to scan your face. If Face ID fails consistently with your sunglasses, try turning off "Require Attention for Face ID" in Settings under Face ID and Passcode. This allows Face ID to work without detecting your eyes through the lenses. If it still fails, the lenses are blocking too much infrared light, and you will need to lower them or remove them to use Face ID.

Can someone unlock my iPhone with Face ID while I am asleep?

By default, Face ID requires you to be looking at the phone with your eyes open ("Require Attention for Face ID" is enabled). This prevents unlocking while you are asleep because your eyes are closed. If you turn off the attention requirement, someone could potentially hold the phone in front of your sleeping face to unlock it. For maximum security, keep the attention requirement enabled.

Why does Face ID ask for my passcode even though it recognized me?

iOS requires your passcode instead of Face ID in several situations: when you have not unlocked the phone for more than 48 hours, after five failed Face ID attempts, after a restart, when you have not used your passcode for more than 156 hours and Face ID has not been used in the last 4 hours, after an emergency SOS call, or when a remote lock command has been received. These are security requirements that cannot be overridden.

Will a cracked screen break Face ID permanently?

It depends on where the crack is. A crack that runs through the notch or Dynamic Island area, where the TrueDepth camera sensors are located, can damage or misalign the sensors and disable Face ID permanently. A crack that affects only the display area below the notch typically does not affect Face ID. If your screen is cracked and Face ID stopped working, the TrueDepth camera likely needs repair. Only Apple or Apple Authorized Service Providers can replace the TrueDepth module without disabling Face ID.

Can I use Face ID with a face mask?

Starting with iOS 15.4, iPhones with Face ID support unlocking while wearing a mask. This feature focuses on the area around your eyes to authenticate. Go to Settings, then Face ID and Passcode, and enable "Face ID with a Mask." You can also add glasses as a recognized accessory within this setting. Note that mask-compatible Face ID is slightly less secure than full-face recognition and is only available on iPhone 12 and later models.

Photo Geotagging and EXIF Metadata Tool

Missing Location Metadata in Your Images?

Add GPS latitude, longitude and EXIF tags to your photos so every image carries a record of where it was taken.

Try It for Free
Ryan Mitchell
Written by

Ryan Mitchell

Ryan Mitchell is a tech journalist and troubleshooting specialist based in Austin, Texas. With over eight years of experience covering consumer electronics, he has written for several technology publications and currently focuses on helping everyday users solve common device problems. Ryan holds a degree in Information Technology from the University of Texas and is an Apple Certified Support Professional. When he is not testing the latest gadgets, he volunteers at a local community center teaching digital literacy to seniors.

Related Posts

Explore more tutorials & local SEO guides